Introduction:
The joint de hublot, often referred to as the manchette by professionals, is a large rubber seal that ensures the watertightness between the drum of your washing machine and the door. Over time, this seal may wear out or become damaged, leading to leaks and inefficiency in your washing machine. In this article, we will discuss how to change the door seal of a washing machine, replace a leaking door seal, and provide step-by-step instructions on how to replace the hublot seal of a washing machine.
How to Change the Door Seal of a Washing Machine:
Changing the door seal of a washing machine is a relatively straightforward process that can be done by following these steps:
1. Unplug the washing machine and disconnect it from the water supply.
2. Open the door of the washing machine and locate the existing door seal.
3. Remove the retaining ring or clamp that holds the door seal in place.
4. Carefully peel off the old door seal from the drum and the door.
5. Clean the area where the door seal was attached to remove any residue.
6. Install the new door seal by aligning it with the drum and the door.
7. Secure the new door seal in place with the retaining ring or clamp.
8. Reconnect the washing machine to the water supply and plug it back in.
9. Run a test cycle to ensure that the new door seal is installed correctly and there are no leaks.
Replacing a Leaking Hublot Seal of a Washing Machine:
If your washing machine is leaking from the hublot seal, it is important to replace it promptly to prevent further damage. Here is how you can replace a leaking hublot seal:
1. Follow steps 1-5 from the previous section to access the hublot seal.
2. Inspect the hublot seal for any visible signs of damage or wear.
3. If the hublot seal is damaged, carefully remove it from the drum and the door.
4. Clean the area where the hublot seal was attached.
5. Install the new hublot seal by aligning it with the drum and the door.
6. Secure the new hublot seal in place with the retaining ring or clamp.
7. Reconnect the washing machine to the water supply and plug it back in.
8. Run a test cycle to ensure that the new hublot seal is installed correctly and there are no leaks.
current url：https://snkwjs.d232y.com/news/changement-joint-de-hublot-machine-a-laver-10617